Go to…

RAM

Home / RAM

We Service and Repair all RAM cars

  • 2018 RAM 1500

    RAM 1500
    Mileage
    155,960
    Service Date
    5/15/2025
    Services Performed
    • ENGINE OIL FILTER BASE – Remove & Replace – V6,3.6L Eng Housing
    • Drain and fill cooling system
     
    GREG K. gave our service a 5 star review on 5/23/2025

  • 2019 RAM 1500

    RAM 1500
    Mileage
    126,362
    Service Date
    2/7/2025
    Services Performed
    • Mount and balance four tire/wheel assemblies.
    • drained coolant and removed engine cover and the air cleaner assembly. disconnected the egr solenoid and tube and removed the upper intake. unhooked the fuel injectors and started to remove the lower intake and had trouble getting it out as the wire holder is hidden and so far back. got the harness released and removed the lower intake. sucked as much oil out of the valley as i could. removed the oil cooler and cleaned the engine surface. put new seals in the new cooler and installed the new cooler. put new gaskets in the lower intake and installed the lower intake. installed new gaskets in the upper and installed the upper intake. installed egr and filled the cooling system with coolant and started vehicle and let warm up to operating temp while purging air from the system. verified concern has been corrected. the check engine light was on upon arrival because the air intake temperature sensor was unplugged. hooked up scanner to clear the code and the scanner would not power up. traced it to fuse 43 and it was a 3 pronge. replaced fuse and cleared codes.
     
    CAM C. gave our service a 5 star review on 2/7/2025

  • 2014 RAM 1500

    RAM 1500
    Mileage
    261,774
    Service Date
    1/28/2025
    Services Performed
    • TOWED IN – NO START
    • STARTER ASSEMBLY – Remove & Replace – V8,RWD/4WD
     
    ROLF W. gave our service a 5 star review on 1/28/2025

  • 2018 RAM 1500

    RAM 1500
    Mileage
    147,804
    Service Date
    1/6/2025
    Services Performed
    • DRAINED RADIATOR AND UNHOOKED THE FAN SHROUD AND REMOVED THE FAN. UNHOOKED THE RADIATOR HOSES AND REMOVED THE RADIATOR. INSTALLED NEW RADIATOR AND HOOKED UP HOSES AND INSTALLED THE FAN. FILLED WITH COOLANT AND STARTED VEHICLE AND LET WARM UP WHILE PURGING AIR FROM THE SYSTEM. TEST DROVE AND VERIFIED CORRECT OPERATION OF COOLING SYSTEM. DURING TEST DRIVE I NOTICED THE OIL CHANGE STICKER IS OVER BY 3,000 AND THE IS WHEEL BEARING NOISE.
     
    GREG K. gave our service a 5 star review on 1/14/2025